CLI Reference IGMP Snooping Configuration Commands
The following example configures the query interval
on the device:
Ruijie(config)# ip igmp snooping querier
query-interval 100
ip igmp snooping vlan
querier query-interval
Configure the query
interval in VLAN
Supported after release 10.4(3).
ip igmp snooping querier timer expiry
To specify the expiration timer for non-querier, execute the global configuration command
of "ip igmp snooping querier timer expiry". Use no form of this command to restore to the
default value.
ip igmp snooping querier timer expiry num
no ip igmp snooping querier timer expiry
Non-querier expiration
timer (60-300); unit:
second; default: 125
seconds
Global configuration mode.
After globally enabling IGMP querier, if the device is
elected as a non-querier, execute this command to
change the expiration timer for non-querier.
If expiration timer has been configured in the
corresponding VLAN, the value specified in VLAN
will be used first.
The following example configures the non-querier
expiration timer on the device:
Ruijie(config)# ip igmp snooping querier timer
To Next Page
Loading...
Need help?
General