CLI Reference IGMP Snooping Configuration Commands
ip igmp snooping query-max-response-time
This command specifies the time for the switch to wait for the member join message after receiving the
query message. If the switch does not receive the member join message within the specified time, it
considers that the member has left and then deletes the member.
ip igmp snooping query-max-response-time time
no ip igmp snooping query-max-resposne-time
The aging time of the routing interface
that the switch learns dynamically.
Global configuration mode.
You can specify the time for the switch to wait for the member join
message after receiving the query message. If the switch does not
receive the member join message in the specified time, it considers
that the member has left and then deletes the member. This
command lets you adjust the waiting time after receiving the query
message.
Set the aging time of the routing interface that the switch learns
dynamically to 100s.
Ruijie(config)# ip igmp snooping query-max-response-time 100
Configure a multicast routing
interface.
ip igmp snooping source-check default-server
The source IP address check is used to permit one or several IPMC flows from the server of the
specified IP address.
To configure the source IP address check function of IGMP snooping, execute the ip
igmp snooping source-check default-server command in the global configuration
mode. The no form of this command is used to disable the source IP address check
function.
ip igmp snooping source-check default-server address
no ip igmp snooping source-check
To Next Page
Loading...
Need help?
General