CLI Reference IGMP Snooping Configuration Commands
The source port check function takes effect globally. Once it is
enabled, only the IPMC streams from the specified port are permitted.
The following example shows how to enable the source port check
function of IGMP snooping.
Ruijie(config)# ip igmp snooping source-check port
Ip igmp snooping
source-check
default-server
Enable the multicast
source IP address check
function.
ip igmp snooping suppression enable
To enable IGMP snooping suppression, execute the ip igmp snooping suppression enable command
in the global configuration mode. The no form of this command is used to disable IGMP snooping
suppression..
ip igmp snooping suppression enable
no ip igmp snooping suppression enable
Global configuration mode.
After you execute this command to enable the suppression function,
the switch begins to suppress the IGMP v1/v2 report messages.
The following example shows how to enable IGMP snooping
suppression on the device:
Ruijie(config)# ip igmp snooping suppression