CLI Reference NFPP Configuration Commands
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard enable
Enable the anti-ARP attack on
the interface.
show nfpp arp-guard
summary
arp-guard isolate-period
Use this command to set the arp-guard isolate time globally.
arp-guard isolate-period {seconds | permanent}
Set the isolate time, in seconds. The
valid range is 0, or [30, 86400].
The default isolate time is 0, which means no isolation.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard isolate-period 180
nfpp arp-guard
isolate-period
Set the isolate time on the
interface.
show nfpp arp-guard
summary
To Next Page
Loading...
