Ruijie RG-S2600G-I Series - Page 835

CLI Reference NFPP Configuration Commands
icmp-guard rate-limit
Use this command to set the rate-limit threshold globally.
icmp-guard rate-limit { per-src-ip | per-port} pps
Parameter
description
Parameter
Description
per-src-ip
Set the rate limit for each source IP
address.
per-port
Set the rate limit for each port.
pps
Set the rate limit, in the range of
[1,9999]
Default
Settings
The default rate-limit threshold for each source IP address is half of
the value for each port. And the default rate-limit threshold value for
each port varies with the products:
For the S2600G-I series, the default value is 400.
Command
mode
NFPP configuration mode.
Usage
guidelines
N/A
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# icmp-guard rate-limit per-src-ip 500
Ruijie(config-nfpp)# icmp-guard rate-limit per-port 800
Related
commands
Command
Description
nfpp icmp-guard
policy
Set the rate limit and the
attack threshold.
show nfpp
icmp-guard summary
Show the configurations.
icmp-guard trusted-host
Use this command to set the trusted hosts free form monitoring.
icmp-guard trusted-host ip mask
no icmp-guard trusted-host {all | ip mask}