CLI Reference NFPP Configuration Commands
ip-guard rate-limit
Use this command to set the rate-limit threshold globally.
ip-guard rate-limit { per-src-ip | per-port} pps
Set the rate limit for each source IP
address.
Set the rate limit for each port.
Set the rate limit, in the range of
[1,9999]
By default, the the rate-limit threshold for each source IP address and
each port is 20pps and 100pps respectively.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# ip-guard rate-limit per-src-ip 2
Ruijie(config-nfpp)# ip-guard rate-limit per-port 50
Set the rate limit and the
attack threshold.
show nfpp ip-guard
summary
ip-guard scan-threshold
Use this command to set the global scan threshold.
ip-guard scan-threshold pkt-cnt
Set the scan threshold, in the
To Next Page
Loading...
