CLI Reference NFPP Configuration Commands
Set the attack threshold, in pps. The
valid range is [1,9999].
By default, the default rate-limit threshold for the ns-na, rs and
ra-redirect on each port is 15.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# nd-guard rate-limit per-port ns-na 10
Ruijie(config-nfpp)# nd-guard rate-limit per-port rs 5
Ruijie(config-nfpp)# nd-guard rate-limit per-port ra-redirect 5
Set the rate limit and the
attack threshold.
show nfpp nd-guard
summary
nfpp nd-guard enable
Use this command to enable the ND anti-attack function on the interface.
nfpp nd-guard enable
The ND anti-attack function is not enabled on the interface.
Interface configuration mode.
The interface ND anti-attack configuration is prior to the
To Next Page
Loading...
