Ruijie RG-S2600G-I Series - Page 863

CLI Reference NFPP Configuration Commands
Related
commands
Command
Description
show nfpp define
summary
Show the user-defined
anti-attack configurations
trusted-host
Use this command to set the trusted hosts free form monitoring.
trusted-host {mac mac_mask | ip mask | IPv6/prefixlen}
no trusted-host {all | ip mask | IPv6/prefixlen }
Parameter
description
Parameter
Description
ip
Set the IP address.
mac
MAC address.
mac_mask
MAC address mask.
IPv6/prefixlen
IPv6 address and mask length
mask
IP mask.
all
Delete the configurations of all trusted
hosts with the no form of this
command.
Default
Settings
N/A.
Command
mode
NFPP define configuration mode.
Usage
guidelines
The administrator can use this command to set the trusted
host free from monitoring. The ICMP packets are allowed
to sent to the trusted host CPU without any rate-limit and
warning configuration. Configure the mask to set all hosts
in one network segment free from monitoring.
UP to 500 trusted hosts are supported.
Before configuring the trusted-host, the match type must
be configured. If the message type configured by the
match is Ipv4, the Ipv6 trusted addresses are not allowed.
In the same way, if the message type is IPv6, the IPv4