CLI Reference CFM Configuration Commands
cfm
service-instance
md ma
Set the service instance.
show cfm linktrace-info service-instance mep
Use this command to show the linktrace information.
show cfm linktrace-info [service-instance instance-id [mep mep-id]]
Service instance id, in the range of
1-32767.
MEP(maintenance association end
point) id, in the range of 1-8191.
By default, all instances are shown.
The example below shows the linktrace information of one
MEP(maintenance association end point).
Ruijie# show cfm linktrace-info service-instance 1 mep 100
The example below shows all linktrace information of all
MEP(maintenance association end point)s in a service instance.
Ruijie# show cfm linktrace-info service-instance 1
The example below shows all the linktrace information.
Ruijie# show cfm linktrace-info
cfm linktrace
service-instance mep
ttl
Execute the linktrace function.
To Next Page
Loading...
Need help?
General