438
Specification of inlet type
Note that a command error occurs when the number of bytes exceeds the maximum
number of bytes for each product category.
Ignore RFID tag error (omissible)
b Valid range : 0 ~ 9
0 : Unspecified
This mode stops every time a tag error occurs.
1 ~ 9 : Specify how many labels to ignore for RFID tag error
When tag error occurs, retries with next label up to the maximum number of
labels to ignore. With this mode, printer stops when a series of tag errors occur
that exceeds the specified number of errors.
Note
• If this parameter is omitted, the number of retries set under the menu Interfaces->
RFID->Retries ([DC2]PA’s identifier IF, MAX_RETRY_LABEL) is applied instead
Data input format + number of data to write in bytes
Dmmmm
or
dmmmm
Number of data to write
"D" or "d" shows that this field is
for the number of data to write.
Capital "D" indicates that the
data is in ASCII, lower-case "d"
indicates the data is in HEX.
Specify the length of data in bytes
with the number(mmmm) that
comes after "D" or "d".
Specifies the number of bytes for the next parameter
“n: data array to write”. This portion should be written
in bytes, so the number specified for this field does
not change regardless of data format, whether ASCII
or HEX.
Maximum number depends on inlet type.
Valid range :
ICODE (a=2) : 0-160
Tag-it (a=3) : 0-256
my-d (a=5) : 0-1000
Note
• Command error occurs if you specify a value that
exceeds the maximum.
Specify 0 if there is no data to write to user memory.
Data array to write
The character code and maximum number of characters
depends on the data input/output format (ASCII/HEX) as
below:
ASCII Range of available character codes :(00H) -
(FFH)
Valid number of characters :
ICODE (a=2) : 0-160 characters
Tag-it (a=3) : 0-256 characters
my-d (a=5) : 0-1000 characters
The maximum number of digits are
equivalent to the maximum byte size that can
be specified for each inlet.
n Data array to write
HEX Range of available character codes: 0(30H)
-9(39H),A(41H) -F(46H)
Valid number of characters :
ICODE (a=2) : 0-320 characters
Tag-it (a=3) : 0-512 characters
my-d (a=5) : 0-2000 characters
To Next Page
Loading...
Need help?
General
Weight and Dimensions
