565
[Supplemental explanation]
•
This command cannot be used in combination with commands other than <A> and <Z>.
• When this command is received during printing, it will not be processed. It will be processed
after printing is complete.
• It takes about 5 seconds to return all return status to the host after sending this command. If the
port is disconnected before all statuses are returned to the host, RFID tag information will not be
correctly returned and the data other than return status format is returned.
• After sending this command, do not send the next command or data until all status replies are
returned to host.
• When this command turns into an error, it will return “EPC_Tag_Err” in ASCII.
• When the communication protocol is used only for driver or set to Status 3, ACK/NAK is
returned before status reply after this command is sent.
• This command is available when printer is in continuous mode and cutter mode (backfeed after
print), and dispenser mode (backfeed after print). It is not available when in tearoff mode, cutter
mode (backfeed before print) and dispenser mode (backfeed before print).
• This command will not work properly when tag offset is set anywhere other than default position.
• In case where lower power consumption mode is valid, [NAK] is returned until printer does wake
up.
[Sequence]
DC2 ＋ PJ,aa(,aa)(,aa),bb
Host
Printer
STX ＋ aa,bb, ＋ cc:d…d,e…e ＋ETX
Or, STX ＋ aa,bb,＋ cc:e…e ＋ETX
Parent topic Common commands for all languages
To Next Page
Loading...
Need help?
General
Weight and Dimensions
