588
[Supplemental explanation]
•
This command cannot be used in combination with commands other than <A> and <Z>.
• When the issue operation of the printer only is a continuous, cutter (backfeed after print), and
dispenser (backfeed after print), this command can be used. It is not available in tearoff mode,
cutter (backfeed before print) and dispenser (backfeed before print).
• This command will not work properly when tag offset is set anywhere other than default position.
• The command cannot be received while printing. Information cannot be obtained when you
specify sequential printing and multiple labels to print.
• After this command is transmitted, it will take about five seconds by the time all the sending
return status is sent back by the host. Tag information is not correctly sent back when the port
is cut before all the sending return status is sent back by the host, data other than the sending
return status format are sent back, and operate it, please after selecting data.
• Please do not transmit other commands and data until all the status of the defined size is
received by the host after transmitting this command.
• Refer to the following chart if you want to specify the alphabet "A" in ASCII/HEX data formats.
Mode ASCII HEX
Data 'A' "41"
Code 41H 34H,31H
• If the printer is a low power consumption mode is enabled, until it wakes up will return a "NAK".
[Sequence]
D C 2 + PJ,aa(,aa),bb
Host
This product
S T X + aa,bb, + cc:d…d,e…e + ETX
Or STX + aa,bb, + cc:e…e,ff:h…h,ii:k…k + ETX
Parent topic Common commands for all languages
To Next Page
Loading...
Need help?
General
Weight and Dimensions
