Section 08 ENGINE MANAGEMENT (4-TEC)
Subsection 02 (COMPONENT INSPECTION AND ADJUSTMENT)
Besides, throttle lever must reach handlebar grip
without causing strain to cable or brackets. En-
sure throttle lever fully closes on it's stopper.
F01K08A
1
1. Must touch handlebar grip
Ensure throttle body is fully open at full throttle
position. At this position, throttle lever stopper is
almost in contact with throttle body.
NOTE: Apply a light pressure on the throttle plate,
a slight play should be obtained.
CAUTION: If there is no free-play at idle posi-
tion, it may cause poor idling and startability.
Improper cable adjustment will cause strain on
cable and/or damage cable bracket or throttle
lever at handlebar.
To adjust, loosen jam nut then turn adjustment nut
as necessary.
1
F18F07A
23
1. Adjustment nut
2. Jam nut
3. Throttle lever stopper
Tighten jam nut and recheck adju
stment.
WARNING
Make sure idle speed stopper contacts throt-
tle cam when throttle lever is fully released at
handlebar.
Closed Throttle and Idle Actuator Reset
Perform the CLOSED THROTTLE AND IDLE AC-
TUATOR RESET as described in THROTTLE POSI-
TION SENSOR (TPS) in ELECTRONIC MANAGE-
MENT below.
410 smr2004-Complete Line Up
To Next Page
Loading...
