Section02MAINTENANCE
Subsection 01 (PERIODIC INSPECTION CHART)
DESCRIPTION
INTERVAL
I
: Inspect, verify, clean, adjust, lubricate.
Replace if necessary
C
:Clean
L
: Lubricate
R
: Replace
FIRST
10
HOURS
EVERY
25 HOURS
OR
3MONTHS
EVERY
50 HOURS
OR
6MONTHS
EVERY
100 HOURS
OR
1YEAR
PROPULSION SYSTEM
Drive shaft boot and splines (if so equipped) I(2)
Drive shaft protection hose I(2)
PTO flywheel L L
Shifter system/cable (if so equipped) I I
Seal carrier (if so equipped) L L C
VTS (Variable Trim System) (if so equipped) I I
Jet pump reservoir oil and oil level I R
Jet pump cover pusher (if so equipped) I
Impeller shaft seal (7)
Impeller and impeller/wear ring clearance I(2)
Water intake grate I(2)
HULL/BODY
Bailer pick-ups, check for obstructions I I
Hull I I
(1) Every 10 hours in salt water use.
(2) These items have to be initially checked after 25 hours. Thereafter, servicing to be made as specified in
this chart.
(3) Daily flushing in salt water or foul water use.
(4) Except DI models.
(5) Emission-related component.
(6) In salt water use.
(7) Replace at 150 hours or after 2 years, whichever comes first.
(8)
On DI models, replace at 250 hours.
(9)
On DI models, check at 350 hours or 5 years.
smr2004-Complete Line Up 23