SeaDoo GTI - Page 50

Section 02 MAINTENANCE
Subsection 01 (PERIODIC INSPECTION CHART)
4-TEC Models
DESCRIPTION
FREQUENCY
I
: Inspect, verify, clean, adjust, lubricate.
Replace if necessary
C
:Clean
L
: Lubricate
R
: Replace
FIRST
10
HOURS
EVERY
25 HOURS
OR
3MONTHS
EVERY
50 HOURS
OR
6MONTHS
EVER
100 HOURS
OR
1YEAR
GENERAL
Lubrication/corrosion protection L
ENGINE
Engine oil and filter (including cover's O-rings)
R R(7)
Support and rubber mount
I I
Seals and fasteners
I I
Exhaust system fasteners (5) I I
Spark plug (5)
R
Supercharger slipping moment (if so equipped)
I
Supercharger drive gear, shaft and lock washer
(if so equipped)
I(10)
COOLING SYSTEM
Flushing (exhaust system)
C(3)
Hose and fasteners I I
Coolant
(7)
Coolant expansion tank cap/cooling system pressure
test
(4)
FUEL SYSTEM
Throttle cable I
Fuel injection system sensors I I
Fault code reading (1, 5) I
Fuel lines, connections, pressure relief valve and fuel
system pressurization (5)
I I
Throttle body, sensors, fuel lines, fuel rail and
fittings (5)
I I
Air intake silencer fit/tightness I I
Fuel tank straps I I
24 smr2004-Complete Line Up
www.SeaDooManuals.net