Section13PROPULSION
Subsection 01 (JET PUMP)
Anti-Rattle System
Install spring no. 14 on slider no. 13.
F00J0VA
2
1
1. Spring
2. Slider
Insert slider and spring into cover.
NOTE: Align the longer slider tab with hole.
F00J0WA
Apply synthetic grease in the center hole of the
cover.
Install pusher no. 12 into cover. Place the flat side
in front of slider tab.
F00J0XA
Install O-ring no. 15 to cover. Apply jet pump bear-
ing grease on mating surface of cover.
Install cover to jet pump housing making sure to
properly position filler plug on top side. Do not
torque yet, keep a small gap.
Insert a pencil or any other plastic tool in the hole
and push on the slider tab.
CAUTION: Do not use a metal tool to push the
tab. It is possible to damage the inner threads.
Hold tab and torque screws.
Remove pencil or tool to release locking mecha-
nism.
Check if the mechanism worked properly. Push
tab with the pencil or tool; if there is a small play
the installation is correct. If not, redo the proce-
dure.
Verify if the impeller is rotating freely.
Add oil.
Oil Fill
NOTE: It is highly recommended to perform a
leakage test prior adding the oil. See PUMP
PRESSURIZATION in this subsection.
smr2004-Complete Line Up 631
To Next Page
Loading...
