SeaDoo GTI - User Manual

Questions and Answers

W
watkinscarolynSep 7, 2025
Why SeaDoo GTI Boat engine hard to start?
- K
  Kellie McdanielSep 8, 2025
  If your SeaDoo Boat engine is hard to start, it could be due to a defective idle bypass valve, a wrong TPS zero setting, throttle cable adjustment issues, temperature too low for available battery capacity, an air lock in the fuel rail, water in the intake system, water or contamination in the fuel reservoir, mechanical engine failure, a faulty spark plug, or low fuel pressure. If the temperature is too low, the battery capacity is not sufficient for cold temperature. Flush the reservoir and refill with fresh gas if there is water in the fuel reservoir or contaminated fuel. Check the spark plug condition.
A
Alyssa RamosSep 6, 2025
What causes SeaDoo GTI Boat engine smoke in the exhaust (4-TEC series)?
- L
  Lindsey WoodSep 6, 2025
  If your SeaDoo Boat engine (4-TEC series) produces smoke in the exhaust, it could be due to a coolant leak, an intercooler leak, a damaged cylinder head gasket, water ingestion, faulty valve guide seals, an oil level that is too high, a blocked PTO oil scavenge port or scavenge pump malfunction, worn or damaged valve seals, or worn-out oil rings. Check and repair any coolant or intercooler leaks. Check and replace the cylinder head gasket. Inspect the intake manifold for water infiltration. Siphon excess oil.
D
Dakota ClarkSep 4, 2025
Why SeaDoo GTI Boat engine runs too fast (vehicle cannot reach its top speed)?
- J
  Joshua BergSep 4, 2025
  If your SeaDoo Boat engine runs too fast and the vehicle cannot reach its top speed, consider these potential causes: a faulty rev limiter, an improper impeller pitch (too low), an incorrect throttle position sensor (TPS) adjustment, a damaged impeller, jet pump cavitation, or sealing issues with the ride plate, jet pump support, or jet pump. Replace the impeller. Check and reseal the propulsion system or hull/body.
A
Amber BrownSep 3, 2025
Why SeaDoo Boat engine cannot reach maximum RPM?
- B
  Bethany DelacruzSep 3, 2025
  If your SeaDoo Boat engine cannot reach maximum RPM, the following reasons might be the cause: the RAVE valve not opening, a faulty water regulator valve, low fuel pressure, a jet pump related problem, limp home mode being activated, exhaust system blockage or muffler damage, exhaust gases in the bilge due to a leak, a defective supercharger, or battery voltage being too low. Check the fuel pump pressure output. Check and repair any exhaust system blockage or muffler damage. Check the exhaust system for leaks.
E
everettbrianSep 1, 2025
Why SeaDoo GTI Boat engine detonation or pinging?
- R
  Rachel SimmonsSep 1, 2025
  If your SeaDoo Boat engine experiences detonation or pinging, possible causes include: issues with the ignition, a spark plug heat range that is too high, high engine/exhaust temperature, fuel octane too low or poor fuel quality, a disconnected or faulty knock sensor, a bad knock sensor connection, or a bad ECM connection. Check and reset the ignition. Check and change the spark plug to the correct range. Use good quality fuel.
P
pkerrAug 31, 2025
What to do if SeaDoo GTI engine stops when running?
- C
  Christine ParrishAug 31, 2025
  If your SeaDoo Boat engine stops while running, consider these potential causes: the spark plug heat range being too high, improper ignition timing, a compression ratio that is too high, poor injection oil quality, electrical noise, low air pressure, engine stalling at idle, air in the fuel rail, or the engine starting but stopping after approximately 2 seconds. Check and change the spark plug to the correct range. Check and reset the ignition timing. Install genuine parts if the compression ratio is too high. Use proper BOMBARDIER injection oil. Check the air delivery circuit for leaks. Syphon the reservoir and refill with fresh fuel. Check the fuel delivery system for proper fuel pressure and delivery.
J
johnathan00Aug 29, 2025
What causes SeaDoo GTI engine to continually backfire?
- T
  Todd GuzmanAug 29, 2025
  If your SeaDoo Boat engine continually backfires, it could be caused by a weak spark, issues with the spark plugs, incorrect ignition timing, a defective encoder wheel/CPS, problems with the rotary valve, carburetor issues, or intake or exhaust valve leaks. Clean or replace the spark plugs. Check and reset the ignition timing. Check and reset the rotary valve. Check the carburetor. Pressure check the engine for intake or exhaust valve leaks.
M
Matthew HuffmanAug 27, 2025
Why does SeaDoo Boat engine turn slowly?
- M
  Marco KramerAug 28, 2025
  If your SeaDoo Boat engine turns slowly, it could be due to loose battery cable connections, a discharged or weak battery, a restriction in the jet pump, a partial seizure in the jet pump, partial engine hydro-lock, partial engine seizure, a worn starter, the timing chain not guided by the chain guide, or the outside temperature being too low. Check, clean, and tighten the battery cable connections. Check, charge, or replace the battery. Check and clean the jet pump.