Siemens SIMATIC S7-1200 - Page 406

Extended instructions
9.3 Distributed I/O (PROFINET, PROFIBUS, or AS-i)
S7-1200 Programmable controller
406 System Manual, V4.2, 09/2016, A5E02486680-AK
Error_decode
(B#16#....)
Error_code_1
(B#16#....)
Explanation (DVP1)
Description
C4 Internal temporary error. Job could not be carried out.
Repeat the job. If this error occurs often, check your
installation for sources of electrical interference.
C5 DP slave or module not available
C6 Data record transfer was cancelled due to priority class
cancellation.
C7 Job aborted due to warm or cold restart on the DP mas-
ter.
C8 to CF DP slave or module reports a manufacturer-specific re-
source error. Please check the documentation from the
manufacturer of the DP slave or module.
Dx User specific DP Slave specific. Refer to the description of the DP
Slave.
81 00 to FF Error in the initial call parameter (with "RALRM
(Page 394)": MODE)
00
Illegal operating mode
82
00 to FF
Error in the second call parameter
88 00 to FF Error in the eighth call parameter (with "RALRM
(Page 394)": TINFO)
Note
: Refer to the online information system of STEP 7
for immediate access to information on how to interpret
the "TINFO" returned buffers.
01
Wrong syntax ID
23
Quantity structure exceeded or destination area too small
24
Wrong range ID
32
DB/DI number out of user range
3A DB/DI number is NULL for area ID DB/DI, or specified
DB/DI does not exist.
89 00 to FF Error in the ninth call parameter (with "RALRM
(Page 394)": AINFO)
Note
: Refer to the online information system of STEP 7
for immediate access to information on how to interpret
the "AINFO" returned buffers.
01
Wrong syntax ID
23
Quantity structure exceeded or destination area too small
24
Wrong range ID
32
DB/DI number out of user range
3A DB/DI number is NULL for area ID DB/DI, or specified
DB/DI does not exist.
8A
00 to FF
Error in the 10th call parameter
8F
00 to FF
Error in the 15th call parameter
FE, FF
00 to FF
Profile-specific error