Technology instructions
10.3 Motion control
S7-1200 Programmable controller
664 System Manual, V4.2, 09/2016, A5E02486680-AK
The tree selector for the PTO axis does not include
the Encoder, Modulo, Posi
tion monitoring, and
Control loop configuration menus.
After you create the technology object for the axis,
you configure the axis by defining the basic p
a-
rameters, such as the PTO and the configuration of
the drive interface. You
also configure the other
properties of the axis, such as position limits, d
y-
Note
You may have to adapt the values of the input parameters of motion control instructions to
the new dimension unit in the use
r program.
To Next Page
Loading...
