Technology instructions
10.3 Motion control
S7-1200 Programmable controller
System Manual, V4.2, 09/2016, A5E02486680-AK
703
Follow these steps to configure the TM Pulse module:
1. Configure your S7-1200 CPU.
2. Select the required ET 200SP Interface module and place it in the Device View:
3. Add the ET 200SP TM Pulse module:
4. In the Channel configuration, select "2 channels (2A)".
5. Set the Operating mode to "PWM with DC Motor".
6. Set the Diagnostics and Channel parameters as required.
To Next Page
Loading...
