Spectra T50e - Page 107

Chapter 4—Configuring the Library Configuring the Global System Settings
August 2017 User Guide—Spectra T50e Library
108
3. Changethesettingsonthisscreenasrequiredforyourenvironment.
For this setting... Do the following to change.... Default
Library Name Setthenameusedtoidentifythelibraryinmessagesit
sendstomailrecipients.Useanamethathelpsidentifythe
librarytoaremoteuser.
blank
(nonameset)
Refresh Rate UsetheRefresh Rate drop‐downlisttosethowfrequently
theinformationontheBlueScaleuserinterfacescreensis
refreshed.
Notes:
 Youcanmanuallyrefreshthedisplayedinformationat
anytimebyselectingtherefreshbuttonlocatedattheleft
endofthestatusbar(see
StatusBaronpage82).
 Ifyouwanttodisableautomaticrefreshingofthe
display,settherefreshratetonever.
 Ifyouusesomethingotherthanthedefaultrefreshrate
ordisableautomaticrefreshing,youmustresetthe
refreshrateeverytimeyoulogintothelibrary.
1minute
Web Server Port Enteraportnumberfrom0to65,535forthededicated
Ethernetportusedtoaccessthelibrary’sembeddedweb
server.
Thedefaultportnumberis80,whichisappropriatefor
mostinstallationsandisstronglyrecommended.Ifyouuse
aportnumberotherthan80,theportnumbermustbe
explicitlyenteredintothewebbrowserwhenaccessingthe
libraryremotely.
Important: Do not set the web server port to 443. Using
this port number causes the front panel display to
become unstable.
Notes:
 TheWebServerPortfielddoesnotdisplayifSSLis
enabled.
 Ifyouchangethewebserverport,youmustenteracolon
(:)afterthelibrary’sIPaddressandthenthenewport
numberwhenaccessingthelibrarythroughtheBlueScale
webinterface(forexample,192.165.10.11:90).
80
Enable SSL SelecttheEnable SSLcheckboxtoenableSecureSocket
Layer(SSL)accesstotheBlueScalewebinterface.
Important: Enabling SSL configures the BlueScale web
interface to use a secure Internet connection. You must
prefix the IP address with https:// instead of just entering
the IP address when accessing the BlueScale web
interface.
Cleared
(Disabled)