Spectra T50e - Page 146

Chapter 5—Operating the Library Monitoring Your Library
August 2017 User Guide—Spectra T50e Library
144
3. ClickDLM(orDrivesifDLMisnotenabled)todisplaytheDrives
screen.Thisscreenlistsallofthedrivesinthelibrary,alongwithbasic
informationabouteachdriveandtheavailableoperationsforeach
drive.
Note: Theoperationsavailableforeachdrivedependhowyouare
accessingtheBlueScaleuserinterfaceandwhetherornot:
 DLMisenabled
 Thedriveisconfiguredinapartition
 AutoDriveCleanisenabledforthepartition
Figure 88 The Drives screen (when accessed from the operator panel).
Present only when using
the touch screen operator
panel.
Present only when the
drive is in a partition with
Auto Drive Clean enabled.
Present only when DLM is
enabled.
Present only when a drive
was not added to 
the library through the
BlueScale software.