Spectra T50e - Page 152

Chapter 5—Operating the Library Identifying Drives and Partitions in the Library
August 2017 User Guide—Spectra T50e Library
150
Thedriveidentifierisshownas<interface>LTO–DRV<bay>,where:
 <interface>LTOindicatesthetypeofinterfaceusedbytheLTOtape
drive.
 fLTO—FibreChannelLTO
 sLTO—SASLTO
 LTO—SCSILTO
 DRV<bay>isthenumberofthedrivebay.Thedrivebaysare
numberedfrombottomtotop,withdrivebay1(DRV 1orDVR1A)
beingthebottom‐most(seeFigure91onpage149).
Forexample,Figure92showsthedriveidentifierforahalf‐heightSAS
LTOdriveinstalledinthetophalf‐heightdrivebayassLTO‐DRV2Bonthe
Drivesscreen.Thedescriptorindicatesthatthedriveispresentandthatit
ispoweredoff.
Figure 92 The Drives screen showing the component
identifier for a drive (remote access).