Spectra T50e - Page 181

Chapter 6—Configuring and Managing Partitions Creating a Storage Partition
August 2017 User Guide—Spectra T50e Library
179
FullScan UsetheFullScanfeature.Whenenabledbyselectingoneormore
PostScantriggers,FullScanusesaGlobal Sparedriveassignedto
thepartitiontoverifyallofthedataoneachcartridge.See
Using
PostScanonpage247forinformationaboutthisoption.
Notes:
 FullScanisnotavailableunlessaGlobalSparedriveis
configuredforthepartition.
 FullScanisonlyavailableifthepartitionusesFibreChannelor
SASLTO‐4andlatergenerationdrives.Itisnotavailablefor
SCSILTOdrives.
Notselected
andnoScan
triggers
selected
(PostScan
Disabled)
QuickScan UsetheQuickScanfeature.Whenenabledbyselectingoneor
morePostScantriggers,QuickScanusesoneofthedrivesinthe
partitiontoverifythedataonasinglewrap,fromthebeginning
ofthetape(BOT)totheendofthewraportheendofrecorded
data(EOD),whichever
comesfirst.SeeUsingPostScanon
page247forinformationaboutthisoption.
Note: QuickScanisonlyavailableifthepartitionusesLTO‐4or
latergenerationdrives.
Notselected
andnoScan
triggers
selected
(PostScan
Disabled)
QuickScan using
Global Spares
UsetheQuickScanusingGlobalSparesfeature.Whenenabled
byselectingoneormorePostScantriggers,QuickScanusesa
GlobalSparedriveassignedtothepartitiontoverifythedataon
asinglewrap,fromthebeginningofthetape(BOT)totheendof
thewraportheendof
recordeddata(EOD),whichevercomes
first.See
UsingPostScanonpage247for informationaboutthis
option.
Notes:
 QuickScanusingGlobalSparesisnotavailableifaGlobal
Sparedriveisnotconfiguredforthepartition.
 QuickScanusingGlobalSparesisonlyavailableifthe
partitionusesLTO‐4orlatergenerationdrives.
Notselected
andnoScan
triggers
selected
(PostScan
Disabled)
Scan Triggers EnabletheselectedPostScanoptionandconfigureoneormore
triggers.
 Scan After Time—Addthecartridgesinthepartitiontothe
automaticPostScanqueueafterthespecifiednumberofdays
passsincethelastscan.EnterthenumberofdaysintheDays
field.
 Scan After Write—AddacartridgetotheautomaticPostScan
queueeachtimedataiswrittentoit.
 Scan After Read—AddacartridgetotheautomaticPostScan
queueeachtimedataisreadfromit.
Note: Selectinganyofthesetriggersautomaticallyenablesthe
selectedPostScanoption.
Allcleared
(PostScan
Disabled)
Select this option... To.. . Default