Spectra T50e - CHAPTER 16 Technical Support

Chapter 15—Maintaining the Drives Adding or Replacing a Drive
August 2017 User Guide—Spectra T50e Library
460
6. ClickOK.Waitforthelibrarytopoweroffthedrive.
7. WatchthefrontpanelforaFeedbackRequiredscreenindicatingthat
thedrivewassuccessfullyshutdown.
8. Replacethedrive.
a. Accessthebackofthelibraryandidentifythedriveyouneedto
remove.
Note: SeeIdentifytheDrivesintheLibraryonpage149todetermine
thephysicallocationthatcorrespondstothedriveidentifierfor
thedriveyouarereplacing.
b. Ifthedrivehastwointerfaceconnectors,makeanoteofthe
connectertowhichtheinterfacecableisconnected.Youmustuse
thesameconnectorwhenyouconnectthenewdrive.
c. Disconnecttheinterfacecablefromthedrive.
Note: IfyouarereplacingaSCSIdrivethathasaterminatorinstalled,
removetheterminatorandsetitasidetobeinstalledonthenew
drive.
d. Usingyourfingersora#2Phillipsscrewdriver,loosenthecaptive
screwsthatsecurethedrivesledtothechassis.
Note: Thehalf‐heightdrivehastwocaptivescrewsandthefull‐height
drivehasfourcaptivescrews.
Important
Do not respond to the prompt in the Feedback Required screen or perform any
other operations from the user interface (either locally or remotely) until you
complete the replacement procedure. If you respond before you replace the drive,
the drive you just powered down powers on and configures itself.