EasyManuals Logo

ST STM32G473 User Manual

ST STM32G473
2126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #327 background imageLoading...
Page #327 background image
RM0440 Rev 4 327/2126
RM0440 Reset and clock control (RCC)
338
Bits 31:30 ADC345SEL[1:0]: ADC3/4/5 clock source selection
These bits are set and cleared by software to select the clock source used by the ADC345
interface.
00: No clock selected
01: PLL “P” clock selected as ADC345 clock
10: System clock selected as ADC3/4/5 clock
11: Reserved.
Bits 29:28 ADC12SEL[1:0]: ADC1/2 clock source selection
These bits are set and cleared by software to select the clock source used by the ADC
interface.
00: No clock selected
01: PLL “P” clock selected as ADC1/2 clock
10: System clock selected as ADC1/2 clock
11: Reserved
Bits 27:26 CLK48SEL[1:0]: 48 MHz clock source selection
These bits are set and cleared by software to select the 48 MHz clock source used by USB
device FS and RNG.
00: HSI48 clock selected as 48 MHz clock
01: Reserved
10: PLL “Q” clock (PLL48M1CLK) selected as 48 MHz clock
11: Reserved, must be kept at reset value
Bits 25:24 FDCANSEL[1:0] clock source selection
These bits are set and cleared by software to select the FDCAN clock source.
00: HSE clock selected as FDCAN clock
01: PLL “Q” clock selected as FDCAN clock
10: PCLK clock selected as FDCAN clock
11: Reserved, must be kept at reset value.
Bits 23:22 I2S23SEL[1:0]: clock source selection
These bits are set and cleared by software to select the I2S23 clock source.
00: System clock selected as I2S23 clock
01: PLL “Q” clock selected as I2S23 clock
10: Clock provided on I2S_CKIN pin is selected as I2S23 clock
11: HSI16 clock selected as I2S23 clock.
Bits 21:20 SAI1SEL[1:0]: clock source selection
These bits are set and cleared by software to select the SAI clock source.
00: System clock selected as SAI clock
01: PLL “Q” clock selected as SAI clock
10: Clock provided on I2S_CKIN pin selected as SAI clock
11: HSI16 clock selected as SAI clock
Bits 19:18 LPTIM1SEL[1:0]: Low power timer 1 clock source selection
These bits are set and cleared by software to select the LPTIM1 clock source.
00: PCLK selected as LPTIM1 clock
01: LSI clock selected as LPTIM1 clock
10: HSI16 clock selected as LPTIM1 clock
11: LSE clock selected as LPTIM1 clock

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ST STM32G473 and is the answer not in the manual?

ST STM32G473 Specifications

General IconGeneral
BrandST
ModelSTM32G473
CategoryMicrocontrollers
LanguageEnglish

Related product manuals