141 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
175mA with PLL on, Ethernet cable unplugged
190mA with PLL on, 10BaseT mode
250mA with PLL on, 100BaseT mode
Operating relative humidity
Mechanical dimensions
(excluding RJ45 and power
jack)
EM1001: 75x36x17.5mm
EM1001G: 75x36x19mm
All specifications are subject to change without notice and are for reference only.
Tibbo assumes no responsibility for any errors in this Manual, and does not make
any commitment to update the information contained herein.
Think the above table should contain additional data? Do not just assume that you
know the answer — talk to Tibbo! Remember that the ultimate responsibility for all
decisions you make regarding the use and the mode of use of Tibbo products lies
with you, our Customer.
NB10x0 and IB100x Boards
The NB10x0 and IB100x boards offered by Tibbo allow you to quickly create a
BASIC-programmable communication, control, or data acquisition system from a set
of standard components. A pair of boards -- one network board ("NB"), and one
interface board ("IB") -- form a complete system, as shown on the drawing below.
Both boards have the same outline dimensions.
To Next Page
Loading...
Need help?
General