62Embedded Modules
© Tibbo Technology Inc.
Operating relative humidity
Mechanical dimensions
(excl. leads)
* Implemented in (supported through) firmware.
All specifications are subject to change without notice and are for reference only.
Tibbo assumes no responsibility for any errors in this Manual, and does not make
any commitment to update the information contained herein.
Think the above table should contain additional data? Do not just assume that you
know the answer — talk to Tibbo! Remember that the ultimate responsibility for all
decisions you make regarding the use and the mode of use of Tibbo products lies
with you, our Customer.
EM510 "MiniMo" BASIC/C-programmable IoT
Module
Introduction
The EM510 "MiniMo" (R) device is a miniature stand-alone BASIC-programmable
embedded module, designed to be used in combination with a standard
LED/magnetics RJ45 jack. The combined footprint of the EM510 and a standard RJ45
jack is only 28.5x18.5mm.
The module's hardware mix, which includes 10/100BaseT Ethernet port, a serial port,
and 8 GPIO lines, has been carefully tailored to address the basic needs of
lightweight IoT devices. If your application has a need to store data in files, an
external flash IC can be connected to the EM510. By connecting the WA2000 add-
on module to the EM510 you can also enable Wi-Fi and BLE (Bluetooth Low Energy)
communications.
To Next Page
Loading...
Need help?
General