367 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
This Tibbit was designed for use with the LTPP3 board, which has now been
superseded by the LTPP3(G2) board.
Since USB ports are present on the LTPP3(G2) board itself, this Tibbit is not
required on, nor compatible with the LTPP3(G2).
Details
This Tibbit is only supported on Linux-based boards, such as the LTPP3 board.
7.2.9.57
#51, M1S: CAN Bus [DEPRICATED]
THIS TIBBIT HAS BEEN DEPRECATED
Function: CAN bus transceiver with isolated power
Form factor: M1S
Category: Input/output module
Special needs: [CAN]
Power requirements: 5V/60mA (keep in mind that externally attached CAN devices
may additionally consume up to 200mA)
Mates with: #19, #20, #21
See also: ---
To Next Page
Loading...
Need help?
General