407 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
o Five blue LEDs (for Wi-Fi signal strength indication, etc.)
o Two yellow Ethernet link LEDs, one for each Ethernet port*
o Two green Ethernet activity LEDs, one for each Ethernet port*
·
Serial-over-USB console port
·
Reliable power-on/brown-out reset circuit
·
Power
o Onboard power supply with 8~60V input range provides 2.5A of current and
eliminates the need for power Tibbits
o Current consumption: 400mA@12V (with both Ethernet ports enabled)
·
Dimensions (LxW): 165 x 94mm
·
Operating temperature range: -40°C to 85°C
·
Linux software and applications are upgradeable using the DNF system
* These LEDs are not visible when the board is placed inside the LTPB3.
Tiles, Sockets, Connectors, Controls
The LTPP3(G2) board features eight "M" and eight "C" sockets.
Sockets (S1) through (S15) form four standard tiles.
There are 32 control lines connecting the "M" sockets to the CPU, four for each
socket.
"M" sockets (S1), (S5), (S9), and (S13) have the UART capability.
All "M" sockets have the interrupt capability.
Four "M" sockets have SPI/I2C capability.
To Next Page
Loading...
Need help?
General