471 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
512KBytes or 1024KBytes, entire memory minus
64KB is available to store Tibbo BASIC/C application
and data.
Typical write endurance is 100'000 write cycles per
256-byte sector. See the warning in Flash and
EEPROM Memory.
2048 bytes, 2020 bytes available to store
application data.
Typical write endurance is around 1'000'000 write
cycles per 16-byte EEPROM sector. See Prolonging
and Estimating EEPROM life.
Operating relative humidity
All specifications are subject to change without notice and are for reference only.
Tibbo assumes no responsibility for any errors in this Manual, and does not make
any commitment to update the information contained herein.
Think the above table should contain additional data? Do not just assume that you
know the answer — talk to Tibbo! Remember that the ultimate responsibility for all
decisions you make regarding the use and the mode of use of Tibbo products lies
with you, our Customer.
DS1202
Introduction
The DS1202 is a miniature BASIC-programmable controller designed primarily for
serial-over-IP and serial control applications.
The DS1202 features a multi-channel serial port. The device has a single DB9M
connector and is priced as a single-port product, yet it packs four independent
serial channels. Have no use for those DSR and DTR lines? Turn them into RX and TX
To Next Page
Loading...
Need help?
General