Tibbo EM1000 User Manual

518Companion Products
© Tibbo Technology Inc.
p
Aver
.
2.54
Pin pitch
Dimensions are for reference only. Tibbo assumes no responsibility for any errors in
this Manual, and does not make any commitment to update the information
contained herein.
Ordering Info and Specifications
The GA1000 device is available in two configurations: GA1000 and GA1000L. Use the
GA1000 device with all compatible products except the LTPP3 board. For this board,
order the GA1000L.
A set consisting of the EM1000 and GA1000 modules can be ordered using the
"EM1000G" ordering code (see Specifications and Ordering Info for the EM1000).
Likewise, a set consisting of the EM2000 and GA1000 modules can be ordered as
"EM2000G".
Specifications
Compatibility
GA1000: DS1101, DS1102, EM500, EM1000, EM1001,
EM1206, EM2000, EM2001, TPP2, TPP2(G2), TPP3,
TPP3(G2)
GA1000L: LTPP3
Wireless interface
802.11b/g
Host interface type
SPI
Nominal power supply
voltage (VCC pin)
DC 3.3V, +/- 5%
Operating current (VCC
pin)
Post-reset, before boot: ~65mA;
Fully functional, no data transmission: ~200mA;
During data transmission: ~280mA.
Operating temperature
range
-20 to +70 degrees C
Operating relative
humidity
10-90%
Mechanical dimensions
(excl. leads)
42x19x6.7mm
Packaging
Tray, 30 modules/tray.
All specifications are subject to change without notice and are for reference only.
Tibbo assumes no responsibility for any errors in this Manual, and does not make
any commitment to update the information contained herein.
Think the above table should contain additional data? Do not just assume that you
know the answer — talk to Tibbo! Remember that the ultimate responsibility for all
decisions you make regarding the use and the mode of use of Tibbo products lies
with you, our Customer.

Tibbo EM1000 Specifications

General

Brand	Tibbo
Model	EM1000
Category	Control Unit
Language	English