487 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
- Ethernet LEDs, M (mode) and R (reset) buttons;
- "Right side" LEDs;
- Buzzer control;
- Optional Wi-Fi interface (DS1015 devices only);
- Optional GPRS interface (DS1015 devices only).
·
Left (interface) side of the device:
- Terminal blocks and control lines;
- Opto-isolated inputs;
- Relays;
- RS232/485 port;
- "Left side" LEDs.
8.4.4.1
Ordering Info and Specifications
Device numbering scheme is as follows:
DS1015 devices without "G", "C", or "GC" options are not being offered by Tibbo. If
you want to purchase Ethernet-only device (without any wireless options), then
order DS1005 instead.
External Antenna
The DS1015 can be ordered with Wi-Fi, GPRS, or Wi-Fi and GPRS options. The Wi-Fi
interface works better when equipped with an antenna. In the absence of Wi-Fi
antenna, the Wi-Fi interface still works (relying on a small "chip" antenna on the
GA1000), but the operating range is reduced. The GPRS interface can't work without
the antenna at all. Therefore:
·
The DS1015G device (with Wi-Fi option) will be shipped with Wi-Fi antenna.
·
The DS1015C device (with GPRS option) will be shipped with GPRS antenna.
·
The DS1015GC device (with Wi-Fi and GPRS options) will be shipped with GPRS
antenna. The Wi-Fi interface will rely on the internal "chip" antenna and,
therefore, will have reduced range compared to the DS1015G.
Hardware specifications
DS1005: NB1000 + LB1000
DS1015: NB1000 + LB1000
To Next Page
Loading...
Need help?
General