Tibbo EM1000 - Control Lines

180Boards
© Tibbo Technology Inc.
6
Sensor 7, negative line (-)
5
Sensor 6, positive line (+)
4
Sensor 6, negative line (-)
3
Sensor 5, positive line (+)
2
Sensor 5, negative line (-)
1
Vin (connected to the power input of the NB10x0)
Terminal block 3
Terminal #
Function
9
Relay 3, normally closed line
8
Relay 3, normally opened line
7
Relay 3, common line
6
Relay 2, normally closed line
5
Relay 2, normally opened line
4
Relay 2, common line
3
Relay 1, normally closed line
2
Relay 1, normally opened line
1
Relay 1, common line
Terminal block 4
Terminal #
Function
9
Relay 6, normally closed line
8
Relay 6, normally opened line
7
Relay 6, common line
6
Relay 5, normally closed line
5
Relay 5, normally opened line
4
Relay 5, common line
3
Relay 4, normally closed line
2
Relay 4, normally opened line
1
Relay 4, common line
Control Lines
The following lines of the EM1000 module (located on the NB10x0 network board)
are used to communicate with the IB1005 + SB1005.
In the tables below, "output" means an output of the EM1000, and "input" means an
input of the EM1000.
Opto-isolated inputs
For more information see Opto-isolated Inputs.
Line
Function
Correspondin
g
EM1000 I/O
IC1000
cable line