234Development Systems
© Tibbo Technology Inc.
* I/O pins of the EM1000 module
Required initialization code in Tibbo BASIC/C application
This section assumes that you are familiar with Tibbo BASIC/C and TIDE software.
These are documented in the TIDE, TiOS, Tibbo BASIC, and Tibbo C Manual.
For correct board operation, click Project-> Settings, and select "EM1000" or
"EM1000G" platform. Additionally, click Customize to open a Customize Platform
dialog. In the dialog, double-click the Keypad (kp.) Object line and choose
"Enabled".
The following initialization code should also be added to your project:
To Next Page
Loading...
Need help?
General