27 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
1MB program flash for TiOS and compiled
application binary. TiOS occupies 256KB. The
remaining 768KB can be used to store the compiled
application binary and permanent (unchangeable)
data.
1MB for hardened, fault-tolerant file system. The
entire disk can be used by the application to store
its data .
Typical write endurance is 100'000 write cycles per
256-byte sector. See the warning in Flash and
EEPROM Memory.
2048 bytes, 2020 bytes available for storing
application's data.
Typical write endurance is around 1'000'000 write
cycles per 16-byte EEPROM sector. See Prolonging
and Estimating EEPROM life.
Nominal power supply
voltage (VCC pin)
Reset circuit trip voltage
(VCC pin)
~2.95V on power-up (i.e. when the voltage on VCC
is rising)
~2.85V on brown-out (i.e. when the voltage on
VCC is dropping)
Operating current (VCC
pin), not including
hardware consumed by an
add-on modules plugged
into the EM2000
100mA at full speed, 100BaseT Ethernet mode
Backup power voltage
range (VCCB pin)
Backup current (VCCB pin)
13uA when the EM2000 is not powered (0V on
VCC)
Operating relative humidity
Mechanical dimensions
(excl. leads)
EM2000: 38.4x28.4x5.5 mm
EM2000W: 38.4x28.4x11.0 mm
Plain EM2000 devices: tube, 10 modules/tube
All other variants: tray, 30 modules/tray
All specifications are subject to change without notice and are for reference only.
Tibbo assumes no responsibility for any errors in this Manual, and does not make
any commitment to update the information contained herein.
Think the above table should contain additional data? Do not just assume that you
know the answer — talk to Tibbo! Remember that the ultimate responsibility for all
decisions you make regarding the use and the mode of use of Tibbo products lies
with you, our Customer.
To Next Page
Loading...
Need help?
General