384Tibbo Project System (TPS)
© Tibbo Technology Inc.
§
7*/8 bits/character
§
Full-duplex mode with RTS/CTS and XON/XOFF flow control
§
Half-duplex mode with direction control
§
Encoding and decoding of Wiegand and clock/data streams
o Each module socket has an interrupt capability
o One module socket has PoE capability
o Four remappable synchronous serial ports with SPI and I2C modes
·
Onboard buzzer
·
Connectors for the TFT LCD and sensor keypad of the TPB2L
·
RTC with a backup supercapacitor
·
66KB SRAM for Tibbo BASIC/C variables and data
·
1MB flash for TiOS and application code
·
Additional 1MB flash for the hardened fault-tolerant file system
·
2048-byte EEPROM for data storage
·
Eight onboard LEDs
o Green and Red main status LEDs
o Yellow Ethernet link LED
o Five blue LEDs (for Wi-Fi signal strength indication, etc.)
·
Software-controlled PLL allows selecting full, medium, or low speed
·
Reliable power-on/ brown-out reset circuit
·
Power: 100mA @ 3.3V (100Base-T mode, full speed)
·
Dimensions (LxW): 94 x 94mm
·
Operating temperature range: -40°C to 70°C
·
Firmware is upgradeable through
o The serial port
o Ethernet LAN
o Over-the-air (requires the WA2000 and an iOS or Android device)
·
Tibbo BASIC/C application can be debugged through the Ethernet LAN
·
CE and FCC-certified
* The TPP2(G2) does not support the combination of 7 bits/character mode and
the "none" parity mode.
Programming features
·
Platform objects
o beep — generates buzzer patterns
o bt — in charge of the BLE (Bluetooth Low-Energy) interface
o button — monitors the MD button
o fd — manages the flash memory file system and direct sector access
o io — handles I/O lines, ports, and interrupts
o kp — works with matrix and binary keypads
To Next Page
Loading...
Need help?
General