Tibbo EM1000 User Manual

463 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
Flash memory
512KB for
firmware and
application
storage. No flash
disk
functionality.
1024KB for firmware, application and
data (flash disk).
Typical write endurance is 100'000 write
cycles per 256-byte sector. See the
warning in Flash and EEPROM Memory.
EEPROM
208 bytes, 180
bytes are
available to store
application
data.*
2048 bytes, 2020 bytes are available to
store application data.*
LEDs
Red and green
status LEDs
Yellow Ethernet
link LED
Red and green status LEDs
Yellow Ethernet link LED
Five blue LEDs (can be used for Wi-Fi
signal strength indication)
Wi-Fi**
no
Optional 802.11abgn interface (WA2000)
Optional 802.11bg interface (GA1000) —
OBSOLETE
Display
no
optional 96x32 monochrome OLED
PoE**
optional
optional
Buzzer
no
yes
Processor
T2000
T1000
Operating
frequency and
PLL
80Mhz, no PLL
88MHz, software-controlled PLL
Firmware
upgrades
Through the
serial port or
network
(including cold
upgrade firmware
uploads through
the network).
Through the serial port or network (no
cold upgrades through the network).
Supply voltage
12VDC nominal (min. 9V, max. 18V)
Operating
temperature
range
-5 ~ 70 degrees C
Operating
relative
humidity
10 ~ 90%
Mechanical
dimensions
90x48x25mm
Carton
dimensions
137x99x70mm
* Typical write endurance is around 1'000'000 write cycles per EEPROM sector. See
Prolonging and Estimating EEPROM life.
** Wi-Fi and PoE options are mutually exclusive.
All specifications are subject to change without notice and are for reference only.
Tibbo assumes no responsibility for any errors in this Manual, and does not make
any commitment to update the information contained herein.

Tibbo EM1000 Specifications

General

Brand	Tibbo
Model	EM1000
Category	Control Unit
Language	English