51 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
General-purpose I/O line 5 (P0.5);
TX, W1, dout output of the serial port 2;
Interrupt line 5.
General-purpose I/O line 4 (P0.4);
RX, W1, din input of the serial port 2;
Interrupt line 4.
General-purpose I/O line 6 (P0.6);
RX, W1, din input of the serial port 3;
Interrupt line 6.
General-purpose I/O line 7 (P0.7);
TX, W1, dout output of the serial port 3;
Interrupt line 7.
Positive power input, 3.3V nominal, +/- 5%,
max. current consumption 230mA (100BaseT,
PLL on).
General-purpose I/O line 0 (P0.0);
RX, W1, din input of the serial port 0;
Interrupt line 0.
General-purpose I/O line 1 (P0.1);
TX, W1, dout output of the serial port 0;
Interrupt line 1.
General-purpose I/O line 2 (P0.2);
RX, W1, din input of the serial port 1;
Interrupt line 2.
General-purpose I/O line 3 (P0.3);
TX, W1, dout output of the serial port 1;
Interrupt line 3.
Notes:
1. This line is 5V-tolerant and can be interfaced to 5V CMOS devices directly.
2. This line can serve as an RTS/Wout/cout line of a serial port (provided that this
does not interfere with any other function).
3. This line can serve as a CTS/W0&1in/cin line of a serial port (provided that this
does not interfere with any other function).
Additional connector
Green status LED control line.
Red status LED control line.
General-purpose I/O line 16 (does not belong to
any port);
square wave output line.
General-purpose I/O line 8 (P1.0).
General-purpose I/O line 9 (P1.1).