Tibbo EM1000 User Manual

84Embedded Modules
© Tibbo Technology Inc.
UART capabilities
Baudrates up to 460'800bps;
none/even/odd/mark/space parity and 7/8
bits/character.
Number of I/O lines
8 lines (this does not include the TX and RX lines of
the serial port);
all 8 lines are combined into an 8-bit port;
2 lines can be used as interrupt lines.
Max. load current for each
I/O line
10mA
Flash memory
512 KBytes, 320KBytes are available to store a
compiled Tibbo BASIC/C application;
this memory cannot be used as a flash disk.
EEPROM memory
208 bytes, 180 bytes are available to store
application data.
Typical write endurance is around 1'000'000 write
cycles per 8-byte EEPROM sector. See Prolonging
and Estimating EEPROM life.
Nominal power supply
voltage (VCC pin)
DC 3.3V, +/- 5%
Required external reset
circuit trip voltage
2.9-3.0V
Operating current (VCC
pin)
260mA
Operating temperature
-40 to +70 degrees C
Operating relative humidity
10-90%
Mechanical dimensions
(excl. leads)
18.5x16.0x6.5mm
Pin diameter
0.4mm
Packaging
Tray, 30 modules/tray
*Minimo is a registered trademark of Tibbo Technology Inc.
All specifications are subject to change without notice and are for reference only.
Tibbo assumes no responsibility for any errors in this Manual, and does not make
any commitment to update the information contained herein.
Think the above table should contain additional data? Do not just assume that you
know the answer — talk to Tibbo! Remember that the ultimate responsibility for all
decisions you make regarding the use and the mode of use of Tibbo products lies
with you, our Customer.

Tibbo EM1000 Specifications

General

Brand	Tibbo
Model	EM1000
Category	Control Unit
Language	English