TP-Link T1600G-52PS Cli Reference Guide

11
Interface Configuration Mode can also be divided into Interface Ethernet, Interface
link-aggregation and some other modes, which is shown as the following diagram.
The following table gives detailed information about the Accessing path, Prompt of each mode
and how to exit the current mode and access the next mode.
Mode Accessing Path Prompt
Logout or Access the next
mode
User EXEC
Mode
Primary mode once it
is connected with the
switch.
T1600G-52TS>
Use the exit command to
disconnect the switch.
Use the enable command to
access Privileged EXEC mode.
Privileged
EXEC Mode
Use the enable
command to enter
this mode from User
EXEC mode.
T1600G-52TS#
Enter the exit command to return
to User EXEC mode.
Enter configure command to
access Global Configuration
mode.
Global
Configuration
Mode
Use the configure
command to enter
this mode from
Privileged EXEC
mode.
T1600G-52TS (config)#
Use the exit or the end command
or press Ctrl+Z to return to
Privileged EXEC mode.
Use the interface
gigabitEthernet
port or
interface range gigabitEthernet
port-list command to access
interface Configuration mode.
Use the vlan vlan-list to access
VLAN Configuration mode.
Global Configuration
Mode
Privileged EXEC
Mode
User EXEC Mode
Interface Configuration Mode
Interface gigabitEthernet
Interface link-aggregation
Interface range gigabitEthernet
Interface range link-aggregation
Interface vlan
……
VLAN Configuration Mode

TP-Link T1600G-52PS Specifications

General

Brand	TP-Link
Model	T1600G-52PS
Category	Switch
Language	English