TP-Link T1600G-52PS Cli Reference Guide

12
Mode Accessing Path Prompt
Logout or Access the next
mode
Interface
Configuration
Mode
Layer 2 Interface:
Use the interface
gigabitEthernet
port, interface
port-channel lagid or
interface range
gigabitEthernet
port-list command to
enter this mode from
Global Configuration
mode.
T1600G-52TS (config-if)#
or
T1600G-52TS(config-if-rang
e)#
Use the end command or press
Ctrl+Z to return to Privileged
EXEC mode.
Enter the exit or the # command
to return to Global Configuration
mode.
A port number must be specified
in the interface command.
Interface
Configuration
Mode
Layer 3 Interface:
Use the no
switchport
command to enter
Routed Port mode
from Interface
Configuration mode.
Use the interface
vlan
vlan-id
command to enter
VLAN Interface mode
from Global
Configuration mode.
Use the interface
loopback id
command to enter
Loopback Interface
mode from Global
Configuration mode.
T1600G-52TS (config-if)#
or
T1600G-52TS(config-if-rang
e)#
Use the switchport command to
switch to the Layer 2 interface
mode.
Use the end command or press
Ctrl+Z to return to Privileged
EXEC mode.
Enter the exit or the # command
to return to Global Configuration
mode.
VLAN
Configuration
Mode
Use the vlan vlan-list
command to enter
this mode from
Global Configuration
mode.
T1600G-52TS (config-vlan)#
Use the end command or press
Ctrl+Z to return to Privileged
EXEC mode.
Enter the exit command or the #
command to return to Global
configuration mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a Telnet/SSH connection.
2. Each command mode has its own set of specific commands. To configure some
commands, you should access the corresponding command mode firstly.

TP-Link T1600G-52PS Specifications

General

Brand	TP-Link
Model	T1600G-52PS
Category	Switch
Language	English