Sievers TOC-R3 Operation and Maintenance Manual
DLM 95000-01 EN Rev. A 24 © Veolia 2023
WARNINGS
ENGLISH
Warnings
This symbol on the instrument indicates that the user should refer to the
manual for operating instructions.
This symbol indicates the European Union Directive 2012/19/EU for
waste electrical and electronic equipment (WEEE) requires disposing the
Analyzer separately from standard waste.
This symbol indicates the protective earth terminal (ground) for the
Analyzer.
To avoid potentially dangerous electric shock or burning, turn off power
and disconnect from the power supply before opening the Analyzer. Use
caution when touching any electronic or furnace components. Any
operation requiring access to the inside of the Analyzer, including
installation of maintenance items, could result in injury.
If this instrument is used in a manner not specified by Veolia, the
protection provided by the instrument may be impaired.
Use a 2-person lift. This instrument weighs over 18 kg (40 lb). It is the
policy of OSHA and Veolia to require a 2-person lift for items weighing
over 18 kg (40 lb). Lifting and carrying the Analyzer should be done with
two people handling the unit by the metal enclosure only.
This is a Safety Class I product. It must be must be attached to a
grounded power source. To avoid damage to the Analyzer and the
chance of injury, make sure the Analyzer is connected to a power line of
the proper voltage.
This is a Class A product. In a domestic environment, this product may
cause electromagnetic interference. Take adequate measures to correct
the interference.
The pressure of the compressed gas at the Analyzer’s gas inlet must not
exceed 1 Bar (100 kPa, 14.5 psig). Use only dry, oil-free air (Instrument
Air ANSI 7.0.1) or nitrogen.
Secure all gas cylinders to an immovable structure or permanent wall.
Wear eye protection when using compressed gases to avoid possible eye
injury. Only use regulators designed for use with the selected gas. Store
compressed gases in accordance with all safety codes.
To Next Page
Loading...
Need help?
General