Xerox Phaser 6180 - Servicing Electrical Components; Servicing Mechanical Components

viii Phaser 6180 Color Laser Printer Service Manual
Servicing Electrical Components
Before starting any service procedure, switch the printer power Off and
unplug the power cord from the wall outlet. If you must service the printer with
power applied, be aware of the potential for electrical shock.
W
arn
i
ng
Do not touch any electrical component unless you are instructed to do so
by a service procedure.
Servicing Mechanical Components
When servicing mechanical components within the printer, manually rotate
the Drive Assemblies, Rollers, and Gears.
W
arn
i
ng
Do not try to manually rotate or manually stop the drive assemblies while
any printer motor is running.
Servicing Fuser Components
W
arn
i
ng
This printer uses heat to fuse the toner image to paper. The Fuser is
VERY HOT. Turn the printer power Off and wait at least 5 minutes for the
Fuser to cool before you attempt to service the Fuser or adjacent
components.
s6180-256
s6180-257