6-6 Phaser 6180 Color Laser Printer Service Manual
Adjustments and Calibrations
Calibrations
Initializing Print Meter
This process initializes the Print Meter.
1. From the Control Panel, press the Menu button.
2. Press the Up Arrow or Down Arrow button to find Admin Menu. Press
the OK button.
3. Press the Up Arrow or Down Arrow button to find Maintenance Mode.
Press the OK button.
4. Press the Up Arrow or Down Arrow button to find Init PrintMeter. Press
the OK button.
5. Are you sure? message is displayed. Press the OK button to start the
process.
6. Initialized message is displayed. The Maintenance Mode - Init
PrintMeter menu is displayed when the process is completed.
Initializing NVM (NVRAM)
This process initializes the settings stored in the NVRAM except for the
network settings. The NVRAM is a non-volatile memory that stores the printer
settings even after the power is turned Off. After executing this function and
restarting the printer, all the menu parameters are reset to their default values.
1. From the Control Panel, press the Menu button.
2. Press the Up Arrow or Down Arrow button to find Admin Menu. Press
the OK button.
3. Press the Up Arrow or Down Arrow button to find Maintenance Mode.
Press the OK button.
4. Press the Up Arrow or Down Arrow button to find Initialize NVM. Press
the OK button.
5. Are you sure? message is displayed. Press the OK button to start the
process.
6. Initializing... --> Initialized messages are displayed.
7. The Maintenance Mode - Initialize NVM menu is displayed when the
process is completed.
8. Turn the printer power Off and back On.
To Next Page
Loading...
