Xerox Phaser 6180 - Registration Clutch (PL3.1.19)

Phaser 6180 Color Laser Printer Service Manual 41
Service Parts Disassembly
Registration Clutch (PL3.1.19)
1. Remove Tray 2.
2. Remove the Rear Cover (page 8-11).
3. Remove the Right Side Cover (page 8-12).
4. Remove the Drive Assembly (page 8-76).
5. Disconnect the Registration Clutch connector P/J233.
6. Release the gray Registration Clutch wiring harness from the clamp, the
hook on the printer frame, and the clamp of the Feeder (PL3.2.1).
7. Remove the E-ring securing the Registration Clutch to the Feeder.
8. Remove the Registration Clutch from the Feeder.
R
ep
l
acemen
t
N
o
t
e
R
ep
l
acemen
t
N
o
t
e
Ensure to match the color of the Clutch Harness and the color of the
Clutch positioning rib. The Registration Clutch Harness is Gray.
s6
1
80
-2
5
4
Gray
Gray
P/J233
Gray