Xerox Phaser 6180 - Tray and Paper Errors; Load Tray 1 (MPT) (Paper Mismatch)

Phaser 6180 Color Laser Printer Service Manual 3-53
Error Messages and Codes
Tray and Paper Errors
Load Tray 1 (MPT) (Paper Mismatch)
The paper size mismatch is detected in Tray 1 (MPT).
Applicable Chain Link
■ Chain Link 024-958: Load Tray 1 (MPT)
Initial Actions
■ Inspect the tray to ensure that it is free of obstructions, is loaded with
supported paper, and the Guides are adjusted correctly.
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map Reference
■ Tray 1 (MPT) Cover, PL2.1.24
■ Size Switch, PL7.1.18
■ MCU Board, PL9.1.20
■ Registration Sensor Harness,
PL3.2.37
■ Right Side Harness, PL10.1.15
■ Registration Sensor, PL3.2.30
■ Feeder Unit, PL3.2.1
■ Tray 1 (MPT) Feed Roll, PL3.1.10
■ “Map 1 - Electrical and Drive” on
page 10-10
■ “Map 2 - Laser Unit” on page 10-11
■ “Map 4 - LVPS and MCU Board” on
page 10-13
■ “Main Drive” on page 10-34
■ “Feeder” on page 10-36
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the paper size. Does the paper
size meet specifications?
Go to step 2. Replace the
paper with the
correct
specifications.
2 Check the paper size setting. Does the
paper match with the settings in the
Control Panel?
Go to step 4. Correct the
paper settings
in the Control
Panel. Go to
step 3.
3 Does the error still occur? Go to step 4. Complete.