1-2 Phaser 6180 Color Laser Printer Service Manual
General Information
Printer Introduction and Overview
The Xerox Phaser 6180 Color Laser Printer has a single-pass color laser-
design architecture, which offers color and mono print speed at 20/26-ppm,
and resolutions up to 600 x 600 dots-per-inch (dpi). The printer supports
Adobe PostScript 3 and PCL6, USB 2.0, Parallel port, and 10/100 Base-TX
Ethernet.
The Phaser 6180 printer provides a standard 150-Sheet Tray 1 (MPT) and a
standard 250-Sheet Tray 2. Tray 1 (MPT) supports specialty media, card
stock, and envelopes. The Output Tray holds 300 sheets facedown.
The printer options add memory, paper capacity, and functionality. Memory
upgrades are available to increase the standard RAM from 128 up to 1152 MB
maximum. A 550-Sheet Feeder is available as an option. Auto-duplexing is
available and no tools are required to install the Duplex Unit. The Multi-
Protocol Network Card expands the supported network protocols.
Technical Support Information
The Xerox Phaser 6180 Color Laser Printer Service Manual is the primary
document used for repairing, maintaining, and troubleshooting the printer.
To ensure complete understanding of this product, participation in Xerox
Phaser 6180 Service Training is strongly recommended. To service this
product, Xerox certification for this product is required.
For updates to the Service Manual, Service Bulletins, knowledge base, etc.,
go to:
■ Xerox Global Service Net - https://www.xrxgsn.com/secure/main.pl
■ Service Partners: http://www.office.xerox.com/partners
For further technical support, contact your assigned Xerox Technical Support
for this product.
To Next Page
Loading...
