Xerox Phaser 6180 - Parameter Setting

Phaser 6180 Color Laser Printer Service Manual 6-7
Adjustments and Calibrations
Parameter Setting
This function reads/writes the parameter values, errors, and life counter
values stored in the printer.
N
o
t
e
Print the parameter list from the Service Mode > Parameter before
changing the registration value.
To access the Parameter list:
1. Turn the printer power Off (if the printer is On).
2. Simultaneously press the Up Arrow and Down Arrow buttons and turn
on the printer.
3. The Service Mode menu is displayed.
4. Press the Up Arrow or Down Arrow button to find Parameter. Press the
OK button.
5. Select the appropriate item to change (i.e., Slow Scan KtoP). Press the
OK button.
6. Enter the appropriate range using the Up Arrow or Down Arrow button.
Press the OK button.
7. The new value “# *” is displayed.
N
o
t
e
“*” = data has been saved
8. Press the Cancel button to return to the Parameter menu.
Shifts the print area in
this direction by reducing
the value.
Shifts the print area in
this direction by reducing
the value.
Shifts the print area in
this direction by
increasing the value.
Shifts the print area in
this direction by
increasing the value.
Slow Scan K to P
Slow Scan 600 M,Y,C
Slow Scan 1200 M,Y,C
Fast Scan K to M,Y,C
Fast Scan 2 K to M,Y,C
Fast Scan Tray 1 (MPT), Tray 2, Tray 3
Fast Scan Duplex
Image Side
Default Value
Default
Value
s6180-397