Xerox Phaser 6180 - Deve Motor Error

3-88 Phaser 6180 Color Laser Printer Service Manual
Error Messages and Codes
Deve Motor Error
The Deve Motor has failed.
Applicable Chain Link
■ Chain Link 093-320: Deve Motor Error
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ MCU Board, PL9.1.20
■ Feeder Kit, PL3.2.1
■ Right Side Harness, PL10.1.15
■ Main Drive, PL8.1.2
■ “Map 1 - Electrical and Drive” on
page 10-10
■ “Map 4 - LVPS and MCU Board” on
page 10-13
■ “Main Drive” on page 10-34
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the Print Cartridges for correct
installation. Are the Print Cartridge
correctly installed?
Go to step 3. Reseat the Print
Cartridges. Go
to step 2.
2 Does the error still occur? Go to step 3. Complete.
3 Check the wiring harness connectors
P/J22 and P/J222 between the MCU
Board and the Main Drive. Are the
connectors securely connected?
Go to step 4. Reconnect the
connectors. Go
to step 4.
4 Perform the Deve Motor test
(page 4-43): Service Mode > Engine
Diag > Motor Test > Deve Motor.
During the test, close the Front Cover.
Does the Motor operate properly?
Replace the
MCU Board
(page 8-87).
Go to step 5.
5 Check the Main Drive for correct
installation. Is the Main Drive correctly
installed?
Go to step 6. Reseat the Main
Drive.
6 Does the error still occur? Go to step 7. Complete.